SQMIZE® ELITE CLUB SQ-1000RS Super Weight Pin, Set of 2
SQMIZE® ELITE CLUB SQ-1000RS Super Weight Pin, Set of 2
€49.95
Available, delivery time: 2-5 Tage
SQMIZE® ELITE CLUB SQ-1000RS Super Weight Pin, Set of 2
When adding extra weight to a weight stack, it is usually loaded on one side. This works, but it creates a lateral moment across the guide system: instead of moving centrally, the weight stack presses against the guide rods. That's why the SQMIZE® ELITE CLUB SQ-1000RS comes as a set of two pins. One pin passes through the weight stack, and the second is attached on the opposite side, distributing the load evenly across both sides.
Load Both Sides
Slide the first pin sideways through the weight stack until it emerges on the other side. Then attach the second pin there. Both pins can then hold weight plates, distributing the additional load symmetrically to the left and right of the guide system.
The benefits are not purely mechanical. Two loading sleeves also mean you can accommodate twice as much additional weight at the same loading length compared to a single pin, and work with finer increments. Two 1.25 kg plates, for example, add 2.5 kg in total, distributed across both sides rather than concentrated on one side.
Loading Capacity and Compatibility
Each pin provides 12.5 cm of loading length and has a diameter of 50 mm. This makes it compatible with all standard Olympic weight plates and standard collars. Together, the two pins provide 25 cm of usable loading length.
There is one measurement you should check before ordering: the insertion pin is 9 cm long and has a diameter of 11 mm. The hole in your weight stack must therefore be at least 11 mm in diameter.
Holder with Wing Screws
The set includes holders with galvanized wing screws. They are secured to the machine frame and keep the pins right where they are needed. Wing screws instead of hex bolts mean you can install or reposition the holders without tools.
Solid Steel Construction
The pins are made from solid steel, not tubing. This explains the set's weight of 2.2 kg for this size. For a component that supports heavy weight plates on a 12.5 cm cantilevered loading sleeve, solid steel offers greater load-bearing strength. Bending stress is concentrated at the mounting point, where the full cross-section makes the difference.
The surface is chrome-plated.
SQ-1000RS or SQ-S955-PWP
| Feature | SQ-1000RS | SQ-S955-PWP |
|---|---|---|
| Scope of delivery | 2 pins | 1 pin |
| Loading | Both sides | One side |
| Loading length per pin | 12.5 cm | 14.5 cm |
| Insertion pin diameter | 11 mm | 10 mm |
| Holder | Wing screws | Magnets |
| Material | Solid steel, chrome-plated | Stainless steel |
Technical Specifications
| Dimensions and Material | |
|---|---|
| Overall length per pin | 27.5 cm |
| Loading length per pin | 12.5 cm |
| Loading sleeve diameter | 50 mm |
| Insertion pin length | 9 cm |
| Insertion pin diameter | 11 mm |
| Material | Solid steel, chrome-plated |
| Set weight | 2.2 kg |
| Scope of Delivery | |
|---|---|
| Weight pins | 2 pieces |
| Holder | With galvanized wing screws |
- Set of 2 for symmetrical loading on both sides of the weight stack
- 12.5 cm loading length per pin, 50 mm diameter for Olympic weight plates
- 11 mm insertion pin – check the hole in your weight stack before ordering
- Solid steel construction instead of tubing, with a chrome-plated finish
- Holder with galvanized wing screws, can be repositioned without tools
Login